For example, in my curves, the fans will always spin at 100% speed if the temperature is 95 C. When the minimum or maximum temperature is reached for both of these cards, their corresponding speed will trigger. Next, you need to set a minimum speed and a maximum speed. Basically, you're telling the app, "I want my temperature to never exceed X, but it's okay if it never goes below Y." Both cards require you to set a minimum and a maximum temperature. First, let's focus on the Target and Linear cards since they're very similar to each other.
I've already configured these cards to my personal preference. For case fans, you can use the hottest motherboard, CPU, or GPU sensor as it doesn't matter too much. You are receiving this because you were mentioned.Before you do anything, you need to select a temperature source.įor CPU fans, use one of your CPUrelated sensors (pick the one with the highest temperature to be safe).
Then watch your fans IRL as you slide each to figure out which is which. Just assign a curve to the appropriate control, it should work. On Jun 3, 2022, at 12:41 PM, Rem0o wrote:īut you mentioned the fans stopped during detection right? Don't bother with the speed cards with RPM, or any of the "detected" stuff from the assisted setup. You are receiving this because you were mentioned.Message ID: from my iPhone If you can see your fans changing speed, then you're all good. On Jun 3, 2022, at 7:20 AM, Rem0o That's because since you got multiple fans on the same channel, the RPM detection is bust, so it can't rely on it. You are receiving this because you authored the thread.Message ID: from my iPhone Reply to this email directly, view it on GitHub, or unsubscribe. And is the Mobo Controller set to the Right DC or PWM Control on SYS_Fan 1 corresponding to your Fans Ans what Connection do ther Use 3 Pin DC Control or 4 Pin Pwm Control. On Jun 3, 2022, at 7:13 AM, Audipower wrote:Ĭan you Control this Fans with the Mobo Settings in Bios ? Some Case fans are 1 Speed Only.
0 kommentar(er)
